Configuring Modem for Broadband Connection

There are many type of modems but settings are the same. These settings are applicable to broadband band connection using phone line in INDIA

  • For direct connection i.e INTERNET will be automatically connected when modem is ON. Before performing any setting remove the phone wire connected to modem.

1. Open Internet Explorer or any other latest browser.

2. In Address bar type 192.168.1.1 or 192.168.0.1 or 192.168.1.0 and press enter.

3. It will ask you for username and password, generally it is any of this, if not check your modem manual or back side of modem.

Username : admin password : utstar (for OLD modems)
Username : admin password : admin
Username : admin password : password

4. Go to SETUP and select pvc_0_35

5. Change TYPE to PPPOE.

6. Now fill the username and password provided by BSNL, if you dont know call 1500 and enquire.

7. Save the settings , switch off the modem and connect the phone wire.

When you sitch ON the modem, you will be connected to the WORLD. Enjoy!!!

  • For Dial Up mode i.e you should connect manually every time you switch ON modem,the setting are easy. No need to make any settings in MODEM.
1. Connect LAN & PHONE wire to modem.

2. Go to Start --> Control Panel --> Network and Internet Connection --> Network Connection Go to Start --> Control Panel --> Network Connection

3. Select NEW CONNECTION from file or left task pane.

4. A dialogue box will open, click Next select Connect to Internet and click Next.

5. Select Setup my Connection manually and click next.

6. Now select Connect using broadband connection that requires username and password to connect. NEXT

7. Type ISP name as BSNL or Airtel or any of your choice. NEXT

8. Now fill the username and password provided by BSNL, if you dont know call 1500 and enquire. Click NEXT.

9. Click FINISH and connection dialogue box opens, click CONNECT.

Intenet will be connected if username and password is correct. Enjoy!!

To disconnect just reight click two computers icon next to clock and select DISCONNECT. To Connnect go to START --> Connect To --> select your connection and click CONNECT.








No comments: